Zebra ZM400 Installation Instructions

3
Peel/Rewind Upgrade
Remove the Electronics Cover
7/30/07 ZM400/ZM600 Installation Instruction 79835L-001 B
Remove the Electronics Cover
1.
2.
3.
See Figure 2. Remove the screw and washer securing the electronics cover.
Figure 2 • Locate the Electronics Cover Mounting Screw
4. Close the media door.
Note • Retain all parts removed during disassembly, unless otherwise directed.
Caution • Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
Turn off (O) the printer and disconnect the AC power cord and all data cables.
Caution • While performing any tasks near an open printhead, remove all rings,
watches, hanging necklaces, identification badges, or other metallic objects that could
touch the printhead.
Remove the media and ribbon.
1
Media door
2
Electronics cover
3
Washer
4
Mounting screw
1
2
3
4

Zebra ZM400 Specifications