Need help?Do you have a question about the Zebra Z Series ZM600 and is the answer not in the manual?
General| Memory | 16 MB SDRAM; 8 MB Flash |
|---|---|
| Print Method | Thermal transfer and direct thermal |
| Print Width | 4.09 inches (104 mm) |
| Resolution | 203 dpi/8 dots per mm 300 dpi/12 dots per mm (optional) |
| Connectivity | USB, Serial, Parallel, Ethernet |
| Media Sensors | Reflective Transmissive |
| Media Types | die-cut, continuous, thermal, tag |
| Ribbon Width | 2 in./51 mm to 4.33 in./110 mm |
| Ribbon Length | 450 m/1476 ft |
| Optional Connectivity | ZebraNet 10/100 Print Server |
| Operating Temperature | 40°F to 104°F/5°C to 40°C |
| Storage Temperature | -40°F to 140°F/-40°C to 60°C |
| Humidity | 20% to 85% non-condensing |
| Power Requirements | 90-265 VAC, 47-63 Hz |
Step-by-step instructions for establishing printer-computer connections.
Procedures for safely connecting the printer to an electrical power source.
Step-by-step guide for loading media into the printer for different print modes.
Instructions for properly loading ribbon into the printer for thermal transfer printing.
Procedures for calibrating the printer's sensors for optimal performance.
Guidance on adjusting printhead pressure for optimal print quality.
Recommended schedule and methods for cleaning printer parts.
Procedures for cleaning the printer's printhead and platen roller.
Guide for cleaning the internal media path and sensors.
Steps for cleaning the printer's label cutter mechanism.
A guide to diagnosing and resolving common printer issues.
Explains error messages displayed on the LCD and their solutions.
Identifies print quality issues, causes, and recommended solutions.
Troubleshooting steps for issues related to printer calibration.
Diagnosing and resolving issues with printer communication.
Solutions for common problems encountered with the printer's ribbon.
Information on built-in self-tests to diagnose printer condition.
Instructions for the FEED self-test to determine optimal darkness settings.
Procedure to test printer-host communication interconnections.
To Next Page
