Zebra ZM400 - Install the Rewind Pan

7
Peel/Rewind Upgrade
Install the Rewind Pan
7/30/07 ZM400/ZM600 Installation Instruction 79835L-001 B
Install the Rewind Pan
1. See Figure 7. Place the main frame onto the rewind pan assembly. Ensure the rear ledge of
the main frame rests completely on the rear support in the pan.
Figure 7 • Install the Rewind Pan
Important • Alignment is very important. The platen housing must be inside the mounting
tab of the rewind pan.
1
Main frame
2
Main frame mounting screws (4) item 8 in Table 1 on page 1
3
Rear end cap mounting screws (2)
4
Rear end cap
5
Platen housing mounting screw item 8 in Table 1 on page 1
6
Flat washer, item 7 in Table 1 on page 1
7
Rewind Pan
1
2
3
4
7
2
2
5
6