Zebra ZM400 - Page 6

Peel/Rewind Upgrade
Remove the Base
6
79835L-001 B ZM400/ZM600 Installation Instruction 7/30/07
2. See Figure 6. Remove the two screws that attach the rear cover to the base.
Figure 6 • Remove the Old Base
3. Remove the screw and flat washer securing the platen housing to the base.
4. Remove the four screws and two flat washers securing the main frame and end cap.
5. Lift the main frame off the base assembly.
Note • Do not remove the screws attaching the platen housing to the main frame.
1
Main frame
5
Main frame mounting screws (5)
2
Rear end cap mounting screws (2)
6
Base
3
Rear end cap
7
Platen housing
4
Mounting flat washers (3)
1
2
3
5
5
4
6
7