Printer Setup and Operation
Install the Printer Driver and Connect the Printer to the Computer—Ethernet
84
P1066582-003 ZT400 Series™ User Guide 8/25/15
Configuring the printer with your LAN information (if necessary)
If your printer connected to your network automatically, you do not need to complete this
section. Continue with Adding a Printer from the Zebra Setup Utilities Screen on page 85.
4. Connect the printer to your computer using a USB, serial, or optional parallel port as
instructed in Connect a Computer to the Printer’s USB Port on page 71 or Connect a
Computer to the Printer’s Serial or Parallel Port on page 75.
5. Configure the following printer settings. You can change the values through the Zebra
Setup Utilities (click Configure Printer Connectivity on the Zebra Setup Utilities screen)
or by the ways listed at the following links. Contact your network administrator for the
proper values for your network.
• IP Protocol on page 123 (change the value from ALL to PERMANENT)
• Gateway on page 122 (match the gateway value of your LAN)
• Subnet Mask on page 121 (match the subnet value of your LAN)
• IP Address on page 120 (assign a unique IP address to the printer)
To Next Page
Loading...