Zenner multidata WR3 - Legend

H
S
28
Level 3
Legend
Press the button shortly (S)
to switch through the display
from top to bottom. When
you have reached the last
menu item the device auto-
matically jumps back to the
menu item at the top (loop).
Press the button for about 2
seconds (L), wait for the door
symbol to appear (upper right
corner of the display) and
then release the button. The
menu is then updated resp.
switches to the submenu. The
menu is then updated resp.
switches to the sub-menu.
Hold down the button (H)
until the device switches to
another level or switches
back from the sub-menu.
S
L
H
Back to
Level 1
Sensor type and installation point
Pulse value
Reading residual energy
Basic conguration
Type number
End of battery lifetime
Time
Date
M-Bus address
Baud rate
Input display
Error status
Firmware version
Recall of soware version number
The soware version of the rmware can be accessed
from the display level 3 (display level “rmware
version”).
A detailed display overview including sub-menus is
available upon request.
English