Setup Mode JesterML Operating Manual
73-406-00 Issue 2.0 45 of 73
beamshape parameter is tagged by the desk. The default setting for beamshape
is ‘Channel’.
Position: All/Channel
When set to ‘All’, if one position parameter is changed by moving a wheel, then all
position parameters for the currently selected fixtures are automatically also
tagged by the desk. When set to ‘Channel’, only the adjusted position parameter
is tagged by the desk. The default setting for position is ‘All’. Note that
movement effects are always tagged or untagged in their entirety, it is not
possible to separately tag or untag individual control parameters of a movement
effect.
To leave the Record Options menu, press the down cursor button until <OK> is
selected, and press ENTER. If you have changed the recording Mode, then the desk
will need to process all recorded data to ensure channels are programmed. Any
unprogrammed channels will be programmed by the desk at their default values (0%
for brightness channels, Home value for LTP channels). A pop-up warning will ask
you to confirm that this is OK, since the changes to recorded data cannot be undone.
To Next Page
Loading...
Need help?
General
