48 • Controller Operation
CONTROLLER OPERATION
Carel IR33+ Verify and/or Change Parameters
SETTING PARAMETERS ON THE CAREL IR33+
To set parameters, enter the password and then perform the following steps. Repeat these steps until all parameters have been changed.
Do not forget to conrm parameters after setting them. See step 7 from the previous page on how to conrm settings.
1. Press [UP] arrow key until parameter you want to see is displayed.
2. Press [SET] to enter parameter setting
3. Press [UP] or [DOWN] arrows to set parameter to desired setting.
4. Press [SET] again to exit parameter setting.
To Next Page
Loading...