Reassembly of the air cleaner elements
Hydrostatic steering oil tank
Replacing the filtration element of the hydrostatic steering
When reassembling the air cleaner elements proceed in
the reverse order.
Observe the following points during the element
reassembly:
- Make sure the contact surfaces are clean.
- During the assembly the elements must not get
deformed and after installation they must not vibrate.
- After closing of the cleaner with the lid the whole cleaner
must be perfectly leak-proof.
- After the maintenance of the dry air cleaner ensure
proper functioning of the clogging indicator again.
G715
The tank is accessible after opening the hood. It is found
in the front part on the left side of the tractor.
By dipstick check (A) the height of oil level in hydrostatic
steering tank, keep the level of oil between MIN. and
MAX. marks, see fig. (A).
If necessary, replenish the oil after nut disassembly (1)
and removing the lid of tank.
W3
1 - Dismantle the left rear side plate of the hood
2 - Place a suitable container under the hydrostatic
steering tank
3 - Release the drain screw
4 - Drain oil from the tank
F_02_107
5 - Unscrew the tank lid
6 - Replace the filtration element
7 - Install the new element
XF_02_141
To Next Page
Loading...
