Diesel particle filte
- system failures signalizatio
Diesel particle filter failure codes
Failures in diesel particle system failure are
signalized by a red control lighting up on the dashboard
with engine running and subsequently by an acoustic
signal.
If the failure is not removed, it is signalized with any
following starting of the engine
The code of failure us displayed on a display (1) of the
displaying unit which is accessible after removing the right
cover of the steering console.
The failures are displayed on display (1) in a form of E:
double-figured code of failure
For example: E:36, number 36 representing the code of
failure
If failure is not signalized, operation data of diesel particle
filter system are displayed on the display.
The acoustic signal can be turned off by the button (2). If
the failure has not been removed, the acoustic signal is
active with repeated staring of the engine and can be
turned off again by the button (2).
If the key is in switchbox in 'I' position and the engine is
not started, approximately ten minutes later the diesel
particle filter system starts signalizing a failure. Switch the
key to '0' position and start the engine. The code of failure
on the display E:32 or E:33.
FH12N075
Failure
code E:
Operator´s activity
11, 12, 21,
22, 23, 31,
34, 35, 37,
38, 41, 42,
51, 52, 61,
62
The tractor can be
worked without any
limitations, after
terminating your work,
contact authorized
service and report the
code of failure.
32, 33, Switch the key to '0'
position and start the
engine.
36 Regenerate diesel
particle filter.
To Next Page
Loading...
