Brake fluid replacement
Carbon filter installation instructions
Cleaning the heating filters
The vessel is placed on the rights side and is accessible
after lifting the front bonnet. Keep the level of brake fluid in
the range of 3/4 of the content of the vessel (maximum
height) to 1/2 of the vessel content (minimum height of the
level).
When handling brake liquid, keep absolute
cleanness. Check the brake liquid level daily before
starting your work.
FH12N017
1. Remove the old filter from the air duct orifice in the
place of its mounting.
2. Remove the protective package from the new filter.
3. Insert the filter into the air duct orifice in such a way to
make the air flow direction correspond to the flow direction
through the filter in accordance with the arrow on the filter.
The entering air must first pass through the white dust
filtration layer.
4. Check proper sealing of the filter.
5. Secure the filter.
F13BN029
Recover the filters positioned under the covering grills
over the windshield outside the cabin with regard to the
degree of clogging:
- by shaking
- by blowing with compressed air
Check the filters for clogging daily. Replace heavily
clogged filters.
The safety cab of the tractor is not equipped
with special filters of air aspirated to the cab.
It does not protect the operator from the effect of
aerosols and other harmful substances!
Use a filter with active carbon when working with
harmful substances.
F13BN030
To Next Page
Loading...
