191
MAINTENANCE INSTRUCTIONS
NM13N107 E702 E703
FRONT BONNET OPENING
Opening the bonnet:
Unlock the bonnet by pulling the draw
bar (1) in the direction of an arrow, grip
where the arrows are and heave.
The bonnet is locked in the heaved
position by a gas-fluid prop.
Closing the bonnet:
Pull the bonnet by means of a belt, grip
where the arrows are and snap in the
downward direction so that the lock of
bonnet snaps down.
If you close the front bonnet
prudce, there can be the damage
of headlights bubs placed in the
front bonnet.
CHECK OF ENGINE OIL LEVEL
Check oil level every day, before start of
operation, on the tractor standing on a
horizontal surface. The oil gauge rod (1)
and filling hole (2) are located on the
right side of the engine. Screw out the
gauge rod (1), wipe it with a cloth and
screw in. After re-screwing it out the oil
level shall not be under the lower gauge
mark. Refill oil through the filling hole as
necessary (2).
DISCHARGE OF ENGINE OIL
1. Screw out the drain plug (1), the best
immediately after a drive or warming-
up of the engine to its operating tem-
perature.
2. Discharge oil.
3. Clean the drain plug.
4. Screw the drain plug (1) into the hole.
To Next Page
Loading...
Need help?
General