19
SAFETY INSTRUCTIONS FOR THE USERS
- Use front end loader without additional weights on the tractor (danger of mutual contact). The load of front and rear drive axle
must not exceed the maximum permitted load listed in the manual. The use of front end loader requires mounting of counter
weight in the rear part of the tractor.
- Each working tool was reconstructed for the purpose of specific usage and has its own tolerance of resistance and tightness.
- It is forbidden to use front end loader for cultivating soil and stubbing. Such work needs to be done with a special tool, front end
loader is not designed for doing this.
- Using controls which would set the loader into motion without driver holding the gear shifting lever is strictly forbidden and re-
sults in installation not meeting the prescribed standard.
- To penetrate the loaded material, better use the kinetic energy of the tractor rather than pressing force which causes higher
strain of both the loader and the tractor.
- Do not overload hydraulic parts if the load is too heavy or pistons are in end positions.
- Control the loader exclusively from driver’s seat, if you are sitting on driver’s seat.
- Do not leave the seat if you have not blocked any movement of controls.
- No people can be present in the working zone of the loader.
- When working with a lifted loader, mind electric and external cables etc.
- Loader/tractor set needs to be parked on a horizontal and solid base, the arms of the lifting device must be set in the lower po-
sition. After using the front end loader, park the tractor and lower the tool to the ground.
You will find more information in user’s manual to front end loader.
Important notification:
Work always safely and with consideration.
To Next Page
Loading...
Need help?
General