2.3 Explanations of symbols
Safety instructions are highlighted with warning triangles and are depicted according to the degree of
hazard as follows.
Attention!
General hazardous area. Death or severe injury or significant property damage can occur if the
corresponding precautions are not taken!
Danger due to electric current
Danger by dangerous, electric voltage! Death or severe injury can occur if the corresponding
precautions are not taken!
Information
Important additional information and advice for user.
3 Product overview
3.1 Area of application / Notes on use
The fans / motors are not ready-for-use products, but conceived as components for ventilation
systems (type designation see rating plate).
The fans may not be operated until they are installed in line with their intended use. The supplied and
certified guard grille of ZIEHL-ABEGG SE fans is designed in accordance with DIN EN ISO 13857
Table 4 (from the age of 14 up). In the event of deviations, further structural protective measures must
be taken for safe operation.
•
Any use below -10 °C is dependent on not being subjected to unusual, sudden or mechanical loads
or stresses on the material (see minimal permissible ambient temperature).
•
Corrosion is possible at the cutting edges on sendzimir galvanised parts.
3.2 Functional description
ECblue stands for EC fans and motors with maximum efficiency. Highly efficient, electronically
commutated motors with permanent magnets are used the speed of which is controlled by the
integrated controller.
The devices are constructed in accordance with the general requirement in EN 61800-2 for adjustable
speed electrical power systems and is intended for one-quadrant drives.
3.3 Transport, storage
Attention!
•
Observe the weight specifications (see rating plate) and the permissible carrying loads of the means
of transport.
•
Wear safety clothing / shoes and cut-resistant safety gloves when handling.
•
Do not transport the fan by the connecting cable!
•
Avoid shocks and impacts to the device during the transport.
•
Avoid extreme humidity, heat or exposure to cold (see technical data).
•
Watch out for possible damage to the packaging or fan.
•
Fix pallets during transport.
•
Do not stack pallets.
•
Only handle with suitable hoisting gear.
•
Position the lifting beam transversely to the motor axis. Pay attention to adequate width of the lifting
beam.
•
Never stand underneath the suspended fan because defective transport equipment could cause
death.
Quick Start Guide ECblue BASIC-MODBUS, ECblue BASIC Product overview
L-BAL-F078-GB 2024 Index 005 Part.-No. 00706648-GB
6/32
To Next Page
Loading...
