TETHERED CONTROLLER MX32, RADIO CONTROLLER MX32FU Page 3
Notes to software versions and instruction manual
SOFTWARE and SOFTWARE UPDATES:
Information about the current software version is available on the ZIMO website www.zimo.at as
free download from the “Update & Sound” (“Update – System”) page of the same website.
Information about the currently installed software version of the MX32 (version number and date) is
shown on the first CAB CONF page, accessible with E-Key + 0 (Overview & HW/SW info).
THE SCOPE of this MANUAL:
The MX32 controller is part of the ZIMO digital system, consisting of the (other) important compo-
nents MX10 or MX10EC and the “StEin“ modules.
However, the MX32 can also be used with “older” ZIMO DCC systems (various models of the com-
mand station MX1, “old” accessory modules MX8 and track section modules MX9) as well as with the
Roco Z21 command station, although certain limitations apply (e.g. RailCom is not available if a MX1
or MX9 is used).
ACCURACY of this MANUAL:
The screenshots and the functions described in this manual may differ from the ones in the current
software version, because improvements and enhancements are ongoing.
General information:
This manual reflects (matches) the product- and software version at delivery. The device may
show further features after an update. New versions of this manual are published on the
ZIMO website www.zimo.at .
ZIMO devices should not be operated in extreme surroundings (heat, humidity). The air circu-
lation into and out of the device should not be restricted (i.e. by covering).
The cable connection should not be squeezed or put under physical tension or twisted. In or-
der to have a faultless power- and data transmission, make sure that all connections have a
solid fit.
The device should not sty under voltage unattended. The power supply unit(s) must be dis-
connected from the mains using a switchable socket strip or pulling the plug(s).
Children under the age of 8 years must be under supervision of an adult when operating the
device.
Improper use or opening of the device without consulting ZIMO may lead to danger or loss of
warranty.
Please visit our website http://www.zimo.at for more information about ZIMO products, loco sound files
or software from ZIMO partners.
ZIMO ELEKTRONIK GmbH
Schönbrunner Strasse 188
1120 Vienna
Austria
To Next Page
Loading...