9.0 Control mounts
9.1 General warnings
WARNINGS!
Do not replace the joystick knob with any unauthorised •
item. It may cause hazardous operation and loss of
control of the chair.
It is important that the joystick boot is replaced if it is •
torn or brittle; failure to do so could cause substance
damage to the controller and unexpected movement of
the chair.
Ensure that you always have comfortable access to •
the controls whilst the chair is moving and make sure
that the controller is fixed securely to the chair.
9.2 Attendant control
WARNINGS!
Ensure that you set the speed of the attendant control •
to a speed that you can comfortably follow.
Always turn off the power to the controller when leaving •
the user in the chair. (Fig. 9.1).
9.3 Parallel swing-away control
WARNINGS!
Before adjusting the swing-away arm, switch off the •
controller to avoid accidental displacement of the
joystick which would cause unwanted movement of
your wheelchair.
Keep your fingers and clothing, etc. clear while •
operating the swing-away mechanism.
Be aware that the width of your chair has increased •
if the swing-away arm is out and you may not get
between certain obstacles.
Do not hang any items on or over the parallel swing-•
away remote assembly as this could damage the
swing-away mechanism.
When transferring to and from the wheelchair do not •
use the remote as a means of support.
Ensure the power is switched off while adjusting the •
parallel swing-away arm.
Only operate the wheelchair at low manoeuvring speed •
when the parallel swing-away is in use (Fig. 9.2).
R-net Control
Please refer to your R-net Owner’s Manual for
details.
Fig. 9.1
Attendant control
Fig. 9.2
Parallel swing-away control
To Next Page
Loading...