Zippie Salsa - Page 67

ZIPPIE SALSA & SALSA 67
Model: Zippie Salsa M (mid wheel drive)
max. load (Mass of the test
dummy): 75 kg
The wheelchair Zippie Salsa
conforms to the following
standards:
a) requirements and test
methods for static, impact
and fatigue strengths
(ISO 7176-8)
b) power and control systems
for electric wheelchairs
requirements and test
methods (ISO 7176-14)
c) climatic test in accordance
with ISO 7176-9
d) requirements for
resistance to ignition in
accordance with
ISO 7176-16
e) the product is specified as
a Class B power chair
f) all materials used on this
product conform to EN1021
parts 1 and 2.
ISO7176-15 Min. Max. Comments
Overall length (with leg rest) - 1050 mm with 90° hanger
Overall Width - 600 mm
Total mass (w. batteries) 113 kg 145 kg
Weight of the heaviest individual part - 98 kg Chair with all no tool removal parts taken
off
Static stability - downhill - 17° worst case 40 cm deep seat, 0° tilt, -4°
recline
Static stability uphill - 10° worst case 40 cm deep seat, 30° tilt, 30°
recline
Static stability - sidewards - 13.9° worst case 40 cm deep seat, 0° tilt, 0°
recline
Energy consumption (max. range) - 26 km
Dynamic stability uphill 8 ° 9° tilt/16° recline &max. seat height (not
with balle)
Obstacle climbing (with kerb climber) 75 mm Forward with 6 kph motors
Max. Speed forward 6 kph 10 kph 10 kph only with 10 kph motor option
Min. Braking distance from maximum
speed
1.0 m 1.2 m 1 m for 6 kph motor, 1.2 m for 10 kph
motor
Seat plane angle -5° 30° -5° only with MBL tilt + additional brackets
Effective seat depth 302 mm 402 mm 20 mm increments
Effective seat width 302 mm 402 mm 20 mm increments
Seat height at the front edge 470 mm - set 0° tilt, lowest seat height and no
modules
Backrest angle -4° 16° adjustable in 4° steps with tools
Back height 385 mm 435 mm 25 mm increments
Footrest to seat distance 165 mm 360 mm with 70° hanger
Leg to seat surface angle 110° - with 70° hanger
Armrest to seat distance 150 mm 225 mm adjustable with tools
Front position of the armrests 240 mm 315 mm
Min. turning radius 670 mm - with 70° hanger
Nominal battery voltage - 24 V
Battery cut-off voltage - 16 V for 255 seconds
Battery fusible links - - 150A in line fuse on each battery
Quickie Direct Actuator Control Box
fusible link
- - 15A blade fuse located on AUX supply of
power loom
Mass of the test dummy - 75 kg
EN 12184 Min. Max. Comments
Max. kerb height - 75 mm
Ground clearance - 40 mm
Turning Diameter 1000 mm 1150 mm
Speed control operation force - 2 N
Direction control operation force - 1 N