D3 Series User Manual
Page | 45 Copyright©2023 ZKTECO CO., LTD. All rights reserved.
Function Name Description
Volume
Adjust the volume of the device which can be set between 0 and 100.
Language
Select the language of the WebServer and device.
Display IP when
booting
Enable/Disable the function of display IP when booting.
User ID Masking
When enabled, and then the user is successfully compared and verified, the
User ID in the displayed verification result will be replaced with an * to achieve
secure protection of sensitive private data.
Display Verification
Name
Set whether to display the username in the verification result interface.
Standalone
Communication
Set the communication protocol of the device.
HTTPS
To increase the security of software access, users can enable the HTTPS protocol
to create a secure and encrypted network transmission and assure the security
of sent data through identity authentication and encrypted communication.
This function is enabled by default. This function can be enabled or disabled
through the menu interface, and when changing the HTTPS status, the device
will pop up a security prompt, and restart after confirmation.
Note:
1. After selecting the language and clicking Confirm, the device will automatically reboot and display
the changed language.
2. Then WebServer will not display the switched language until the device reboots and log in again.