7 System Setting
30
Press to set the DST option as
ON.
Press ▲/▼ to select among the entry
boxes, using the numeric keypad to enter
the Enter DST and Standard of DST, and
then press [M/OK] key to save.
Note: The end time of DST cannot be set to next year. More specifically, the end time must be later than the start
time in the same year.
7.7 Bell Settings
Lots of companies need to ring their bells to signal the start and end of work shifts, and they usually manually ring their
bells or use electric bells. To lower costs and facilitate management, we integrate the time bell function into the
attendance device. You can set the alarm start time and duration for ringing the bell based on your requirements, so that
the attendance machine will automatically play the selected ring tone, and stop playing the ring tone after the set duration.
On the initial interface, press and hold [M/OK] key to enter the Main Menu interface, then press ◄/► key to select
System menu and press [M/OK] to enter the System interface, shown as following figure 1:
On the System interface, press ▼ key to select DST and press [M/OK]
key to enter the DST interface, shown as following figure 2.
On the System interface, press ▼ key to select Bell and press [M/OK] key
to enter the Bell interface, shown as following figure 2.
To Next Page
Loading...
Need help?
General
