KF1000 Series User Manual
P a g e |
15
Copyright©2022 ZKTECO CO., LTD. All rights reserved.
3 Installation Set-up
3.1Safety Precautions
Make sure the device in the package is in good condition and all the
assembly parts are included.
Make sure that the operating voltage is the same one labelled on the
attendance device.
Make sure all the related equipment is power-off during the installation.
Keep the device away from water or dampness. Prevent water or moisture
from entering the chassis of the attendance device.
Do not place the device on an unstable case or desk. The device might be
damaged severely in case of a fall.
Do not open the chassis when the attendance device is operating or when
electrical hazards are present to avoid electrical shocks.
3.2Installation Site
The device must be installed indoors adequate clearance is reserved at the air
inlet/exhaust vents for heat dissipation.
3.3Installation Steps
Make sure that the device is installed as per the installation instructions.
Otherwise, you will bear any consequence resulting from your actions.
Step 1: Attach the mounting template sticker to the wall, and drill holes
according to the mounting paper.
Step 2: Fix the back plate on the wall using wall mounting screws.
To Next Page
Loading...
Need help?
General
