To Next PageTo Next PageWhat to do if the ZKTeco Turnstiles indicator is not lighted?
If the indicator light on your ZKTeco Turnstiles doesn't illuminate when the equipment is powered on, check the connection cable and power cable for any damage. Also, ensure that the wiring is not loose, as the problem might be with the power supply or circuit.
General| Type | Tripod Turnstile |
|---|---|
| LED Indicator | Yes |
| Lane Width | 550 mm |
| Working Environment | Indoor/Outdoor |
| Ingress Protection Grade | IP54 |
| Power Consumption | 60W |
| Unlocking Time | 0.2s |
| Material | Stainless Steel |
| Power Supply | AC 100-240V, 50/60Hz |
| Working Temperature | -28°C to 60°C |
| Input Interface | Dry contact signal |
| Throughput Rate | 30 people/minute |
| Communication Interface | RS485 |
Details the procedure for installing the turnstile's arms to prevent transportation damage.
Provides steps for performing a power-on test and verifying device functionality.
Specifies requirements for installing the turnstile on concrete ground and forming a passageway.
Guides on routing power and communication wires through inlets and using cable protection.
Outlines steps for drilling holes, fixing the mounting plate, and securing the turnstile.
