4
Circuit Breaker
Reset Circuit Breaker
1. Turn off power supply.
2. Find circuit breaker on bottom near power cord. Note: In some cases, insects may make nests
under edge of power pack – use caution.
3. Push button in.
4. Turn on power supply.
5. If breaker continues to trip, replace breaker and PC board.
Replace Circuit Breaker
1. Disconnect power supply.
2. Remove 4 screws to remove cover.
3. Disconnect ribbon wire connector from power PCB and set cover aside.
4. Remove 2 push-on wire connectors from back of circuit breaker.
5. Use pliers to squeeze base of circuit breaker and push through hole from the inside.
6. Push new circuit breaker through hole from the outside till it snaps in place.
7. Reconnect 2 push-on wires to back of circuit breaker.
8. Reconnect ribbon wire connector to power PCB.
9. Replace cover with 4 screws.
10. Replace chlorinator on wall.
11. Connect power supply.
Power Cord
Power Cord Replacement
1. Disconnect power cord from power source.
2. Remove 4 screws to remove cover.
3. Disconnect ribbon wire connector from power PCB and set cover aside.
4. Unscrew ground wire from back and disconnect the ground wire.
5. Unscrew posts that attach 3 input wires and remove the fourth wire from the circuit breaker.
6. Use pliers to squeeze base of power cord holder and push through hole from the inside.
7. Unclip power cord holder and transfer to new power cord.
8. Push power cord holder with new power cord through hole from the outside till it snaps in place.
9. Reconnect all wires and screw ground wire to back.
10. Reconnect ribbon wire connector to power PCB.
11. Replace cover with 4 screws.
12. Replace chlorinator on wall.
13. Connect power cord to power source.
To Next Page
Loading...
