Zodiac eXPERT - Page 29

28
4.3.7. "Cover": Connecng a pool cover
If the pool is equipped with a compable electric cover, it can be connected to the appliance in order to automacally
reduce chlorinaon when it is closed: this is the "Cover " mode. It is then automacally acvated when the pool cover
is closed, and chlorinaon resumes at the level determined by the programming on opening the compable electric
pool cover.
Check that the cover is compable and is connected to the appliance on the low-voltage circuit, see § “2.6 I
Connecng auxiliary devices”.
This mode is deacvated by default. To acvate it and congure the producon:
• From the Conguraon/Cover mode, press then to acvate or congure the desired percentage of pro-
ducon (congurable between 10% and 90%).
• Press to conrm.
Recommendaons for use:
• Adjust the producon percentage to between 10% and 30%.
• You may let ORP regulaon manage chlorinaon instead of pool cover mode if water stay warm when
pool cover is closed.
4.3.8. "Intelligent pH" mode
The "Intelligent pH" mode is used to adjust the pH more precisely: it reduces producon as the setpoint is
approached, thus reducing wider uctuaons in pH levels.
This mode is acvated by default. To deacvate it:
• From the Conguraon/Intelligent pH mode, press : "ON" ashes.
• Press to deacvate it ("OFF").
• Press to conrm.
4.3.9. "Ini pH": Inialisaon of pH regulaon
This mode allows the pH measurement to stabilise over a certain me at each start-up, before starng to dose (if
necessary). The inialisaon me can be set to 0, 1, 2 or 4 minutes.
This mode is deacvated by default. To acvate it:
• From the Conguraon/Ini pH mode, press : "OFF" ashes.
• Press to acvate ("ON") and to congure the inialisaon me.
• Press to conrm.
• It is advised to enable this feature and set it to “1 min” to prevent unwanted pH correcve product
injecon upon each lter pump startup.
EN