Zodiac T3 Instructions For Installation And Use

12
❹ Maintenance
• The appliance must be cleaned regularly using clean or slightly soapy water. Do not use solvents.
• Rinse the appliance thoroughly with clean water.
• Never store the cleaner in direct sunlight. Store hoses at, do not wind in order to retain the inial hose shape.
4.1 I Cleaning the lter pump's pre-lter
• Always remove the cleaner from the pool before cleaning or draining the ltraon system.
• Aer cleaning (and before re-immersing the cleaner), start the lter pump and leave to
operate for at least 5 minutes in order to drain the circuit.
• To keep your cleaner operang eciently, the pump pre-lter needs to be maintained regularly by removing the
debris.
• We recommend using the leaf catcher (accessory available as an oponal extra) to collect large debris before it enters
the skimmer and pre-lter.
4.2 I Cleaning the Cyclonic
TM
Leaf Catcher (available as an oponal extra)
• Stop the lter pump.
• Hold the leaf trap under the water and grasp its handle. Using the handle, turn the transparent container unl it
comes away (see image ).
• Remove the transparent container from the water and leave the lid and hoses immersed (see image ).
• Remove the lter using the top handle (see image ).
• Remove the debris and rinse the transparent container with fresh water (see image ).
• Reposion the lter then re-immerse the leaf catcher (see image ).
• Correctly posion the transparent container in the notches of the lid, then twist rmly to clip the 2 parts in place (see
image ).

Zodiac T3 Specifications

General

Pool Type	In-ground
Warranty	2 years
Pool Surface	Concrete, tile, vinyl, fiberglass
Cleaning Coverage	Floor and walls
Power Source	Pool Filtration System
Weight	18.5 lbs
Type	Suction-side pool cleaner