10
❸ Use
3.1 I Operang principle
Hydraulic cleaners are connected to the ltraon system (to a sucon port or skimmer). They use the energy from the
lter pump to move in the pool.
The cleaner's ability to climb the sides depends on the shape of the pool and the water ow rate available.
Debris is aspirated by the cleaner and captured in the pre-lter of the lter pump or in the leaf catcher (accessory
available as an oponal extra).
3.2 I Pool preparaon
• This product is intended for use in private, permanent-installaon, buried or above-ground,
rigid-wall swimming pools since it cannot be easily disassembled and stored.
• Not for use in pools which may be dismantled.
The appliance must operate in pool water with the following properes:
Water temperature Between 15°C and 35°C
pH Between 6.8 and 7.6
Chlorine < 3 mg/ l
• When the pool is dirty, especially when rst installing the cleaner, remove the largest debris using a manual brush
and a net.
• Remove any thermometers, toys and other objects that might damage the appliance.
• Wait at least 4 hours aer adding chemicals to the water before immersing the cleaner.
• Ensure that the ltraon system and the skimmer strainers are clean.
• Direct the discharge nozzles downwards if adjustment is possible (see image ).
• Close the boom plug hole of your pool.
• Stop the lter pump.