Zodiac Vortex EC11 - I Electricity Supply Connection

11
3.6 I Ending the cleaning cycle
• To avoid damaging the equipment:
- Do not pull on the cable to remove the appliance from the pool. Use the handle.
- Do not leave the appliance to dry out in sunlight aer use.
- Store all the elements away from sunlight, humidity and bad weather.
- Screw the protecve cap back on if you unplug the control box power cord.
• Switch o the appliance by pressing .
• When the cleaner is within arm's reach, pick it up by the handle and li it gently out of the pool so that the water it
contains drains into the pool (see image ).
• Place the cleaner vercally in the locaon provided on the caddy (depending on the model) for it to dry out quickly
(see image
).
• Then store it with the control box away from sunlight and any splashes. A protecve cover is available as an opon
(see image
).
3.6.1 "Out of water" mode (depending on the model)
This funcon enables the cleaner to be returned to an exact point at the edge of the pool. When it climbs the wall, the
cleaner sprays a jet of water behind it to make it lighter as it exits the pool.
• Direct the cleaner towards the required pool wall, then make it climb to the water line: hold down to rotate it.
The cleaner moves towards the wall when you release the buon.
Tip to prevent the oang cable from becoming tangled
The cleaner's behaviour is strongly impacted by the tangling of the cable. A cable that is correctly untangled
will guarantee beer coverage of the pool.
• Untangle the cable and lay it out in the sun so that it returns to its original shape.
• Then wind it up carefully and place it on the caddy handle (depending on the model) or on a xed support.