Zodiac Vortex EC11 - I Replacing the Brushes

19
❺ Troubleshoong
• If a problem occurs, before you contact your retailer, please carry out these few simple checks
using the following tables.
• If the problem connues, contact your retailer.
• : Acons to be performed by a qualied technician only.
5.1 I Appliance behaviour
Part of the pool is not correctly
cleaned
• Repeat the immersion steps (see § “3.3 Immersing the cleaner”), varying the
immersion locaon unl you nd the right place in the pool.
The appliance does not stay rmly
on the pool boom
• There is sll air in the appliance's casing. Repeat the immersion operaons
(see § “3.3 Immersing the cleaner”).
• The lter is full or dirty: clean it.
• The lter is clogged: change it.
• The propeller is damaged, contact your retailer
The appliance does not or no
longer climbs the pool sides as it
originally did.
(its electronic programme means
that the appliance does not
systemacally climb the walls).
• The lter is full or dirty: clean it.
• The lter is clogged: change it.
• Even though the water seems clear, microscopic algae are present in your
pool. They are not visible to the naked eye, and they make the sides slippery
and prevent the appliance from climbing. Carry out shock chlorinaon and
slightly reduce the pH. Do not leave the appliance in the water during shock
treatment.
• The brushes are worn: check the wear indicators “4.3 I Replacing the
brushes”, then turn the brushes to verify their rotaon. Replace the brushes
if necessary.
• If the problem connues contact your retailer
The appliance does not move on
start-up.
• Check that the control box's power socket is receiving a power supply.
• Check that a cleaning cycle has been launched and that the lights are on.
• If the problem connues contact your retailer
The cable gets tangled • Do not unroll the enre length of the cable into the pool.
• Place the required length of cable in the pool and spread the rest along the
side of the pool.
The cleaner blocks at the discharge
nozzles or boom plug holes
• Stop the ltraon pump and launch a new cleaning cycle.
• Place the control box in the centre of the pool's length, following the safety
condions, see “3.4 I Electricity supply connecons”. If cleaning is not perfect,
vary the posion of the control box and the cleaner immersion.
The cleaner climbs the walls slowly
and stops under the water line.
The cleaner climbs the walls quickly
and goes past the water line unl it
sucks in air:
• The cleaner may behave dierently according to the type of pool lining; it
may be necessary to modify a parameter, to do so contact your retailer
The control box does not respond to
any buon presses.
• Unplug the power cord from the mains socket, wait 10 seconds and plug it
back in again.
The screen displays the message
when the remote control
mode is acve
• This means that the remote control baeries are too low: change them.