Zodiac Vortex EC11 - I Setting the Time and Programming the Cleaning Cycles (Depending on the Model)

14
3.8 I The remote control (depending on the model)
• Respect the baery polarity.
• Do not recharge the baery, dismantle it or throw it onto a re.
• Do not expose it to high temperatures or direct sunlight.
3.8.1 Switching the remote control on and o
• To switch on: press .
• To switch o: press and hold .
Tip: improve the remote control recepon.
The frequency of the ashing of the led located on the remote control indicates the recepon quality. If the
LED ashes quickly, recepon quality is OK.
For the best communicaon between the control box and the remote control:
- Posion the control box on the caddy.
- Turn the control box towards the pool
- Removal all large obstacles between the control box and the pool.
3.8.2 Direcng the cleaner
• The remote control is equipped with movement sensors to direct the cleaner:
: Forward
: Backwards
: Le turn
: Right turn
: Stop
3.8 Taking the cleaner out of the water (depending on the model)
• Press . The cleaner moves toward the wall and climbs up to the waterline.
3.8.4 Synchronising the remote control with the control box
By default, the remote control is already synchronised with the control box. If replacing the remote control/control box
or if a synchronisaon problem occurs, follow the steps below:
• Place the remote control a maximum of 50 cm away from the control box.
• Connect the control box, check that the display shows the operang me, and that no cleaning cycle is running.
• Switch on the remote by pressing .
• Before the remote control switches to standby (around 45 seconds) press the and buons simultaneously
for 6 seconds.
• Check that synchronisaon was successful by observing the display and the remote LED:
Display on the
control box
Remote LED
Result
Good 0:45
2 seconds
Flashing
• Synchronisaon successful.
FAIL
On steady
• Check the distance between the control box and the remote
control is 50 cm maximum.
• Check the remote control baeries. Replace them if necessary.
If the problem connues contact your retailer.
EN