Effects
ZOOM H4
69
character.
For information on available characters, see page
55. (Note that these are slightly different from
the characters available for the file name.)
7.
Repeat steps 5 and 6 as necessary to
change other characters.
8.
When the name is as desired, press
the center of the [MENU] key twice.
A confirmation message for saving the patch
appears.
NOTE
To retain the changed patch name, you must save
the patch (
→
p. 67). If you switch to another patch
without saving, the patch name change will be
lost.
9.
To return to the 4-track mode top
screen, repeatedly press the center
of the [MENU] key.
Importing a patch
You can import a specific or all patches from
another project into the current project.
NOTE
When you execute the import process, existing
patches in the current project will be overwritten.
Take care not to accidentally erase patches that
you want to keep.
1.
At the 4-track mode top screen,
press the bottom (INPUT MENU) of
the [MENU] key.
The INPUT menu appears.
2.
Bring the cursor to the “EFFECT”
item and press the jog dial.
The EFFECT menu appears. If the effect section
is off, switch it to on.
3.
Bring the cursor to the IMPORT
button and press the jog dial.
The EFFECT PATCH IMPORT screen appears.
NOTE
When the effect section is off, the IMPORT button
is grayed out and cannot be used.
4.
Move the jog dial up/down to select
“ALL PATCHES” (import all patches)
or “EACH PATCH” (import individual
patch). Then press the jog dial.
A screen for selecting the import source project
appears.
IMPORT button
H4_E.book 69 ページ ２００６年９月１日 金曜日 午後７時５６分
To Next Page
Loading...
Need help?
General
