Switching effects
Effects in a patch memory can be replaced with other effects as desired.
1. Use and on the Home Screen to select the patch memory with an effect that you want to
replace (→ Switching patch memories).
2. Use and to select the patch you want to replace.
3. Press .
This opens the LIBRARY Screen that shows all the effects.
When the LIBRARY Screen is open, you can preview the sound of only the selected effect or the entire
patch memory. (→ Setting the sound on the LIBRARY Screen)
4. Use , , and to select effects.
HINT
Turn to show the Effect Adjustment Screen where the parameters of the selected effect can be
adjusted. (→ Adjusting effect parameters)
20
To Next Page
Loading...
