Zoom MULTISTOMP MS-50G+ - Tempo Synchronization; Tap Tempo Input

Tapping to change the tempo.
The BPM, which is used for the tempo synchronization of delay time, for example, can be set separately for
each patch memory.
1. Use and on the Home Screen to select the patch memory for which you want to change
the tempo (→ Switching patch memories).
2. Press to open the LIBRARY Screen. Then, use , , and to select the BPM
module, and press (→ Adding effects).
The BPM module is in the SFX category (yellow) at the left edge of the LIBRARY Screen.
This adds the BPM module to the patch memory.
NOTE
• The BPM module cannot be added if the patch memory already has 6 effects. In this case, delete an effect
from the patch memory first. (→ Deleting effects)
• Each patch memory can only have one BPM module.
3. Press .
The tempo can be set by tapping repeatedly. (Tap tempo)
The indicator blinks at the set tempo interval.
30