Zoom Multistomp MS-70CDR - Troubleshooting Guide; Power and Sound Issues; Noise and Battery Problems; Effect Malfunction Resolution

32
Troubleshooting
Troubleshooting
The unit will not turn ON
t 8IFOSVOOJOH POCBUUFSJFTDPOOFDUBDBCMF
to the INPUT jack to start the unit.
No sound or very low volume
t $IFDLUIFDPOOFDUJPOT
→
P6).
t
Adjust the levels of the effects being used (
→
P8).
t $POmSNUIBUVOJUJTOPUJONVUFNPEF
→
P19).
There is a lot of noise
t $IFDLTIJFMEFEDBCMFTGPSEFGFDUT
t 6TFPOMZBHFOVJOF;00."$BEBQUFS
→
P6).
An effect is not working
t *GUIFFGGFDUQSPDFTTJOHDBQBDJUZJTFYDFFEFE
”DSP Full!” appears on the effect graphic. In
this case, the effect is bypassed (
→
P9).
Batteries lose their charge quickly
t $POGJSNUIBUZPV BSF OPU VTJOHNBOHBOFTF
batteries. The continuous operation time is
about 7 hours with mono input and about 5
hours with stereo input when using alkaline
batteries.
t $IFDLUIFCBUUFSZTFUUJOH
→
P6).
Set the type of battery being used to enable
the remaining charge to be shown more
accurately (
→
P20).
t %VFUP UIFDIBSBDUFSJTUJDTPG UIFCBUUFSJFT
they might be used more quickly in cold.