Zoom Multistomp MS-70CDR User Manual

5
Part Names
Part Names
From the left
Parameter knob 1 [ ]
Turn left and right to adjust the parameter.
Press to open the MENU where you can remove and
rearrange effects and make various settings (
→
P12, 18).
You can also check the firmware version (
→
P22).
Parameter knob 2 [ ]
Turn left and right to adjust the parameter.
Press to open the MEMORY screen where you can
select and save patch memories, and change patch
memories using the footswitch (
→
P10, 11).
Parameter knob 3 [ ]
Turn left and right to adjust the parameter.
Press to change the parameter page (
→
P9).
Up and down cursor keys [ / ]
Press to change the effect type.
Press and hold for 1 second to select the effect category
(
→
P8).
Left and right cursor keys [ / ]
Press to show the effect to the left or right.
Press and hold for 1 second to add a new effect left or
right of the current effect (
→
P12).
Parameter knobs Cursor keys

Zoom Multistomp MS-70CDR Specifications

General

Effects	86
Patches	50 user patches
Display	LCD
Input	1 x 1/4"
Output	1 x 1/4"
Pedal Type	Multi-effects
Bypass Switching	Buffered
Type	Multi-effects
Current Draw	500 mA
Simultaneous Effects	Up to 6
Power	9V DC
Effects Types	Chorus, Delay, Reverb
Power Source	9V DC
Presets	50