Zoom R8 Interface Manual

26
Audio interface manual
Mixer in audio interface mode
In audio interface mode you can make a mix for monitoring using the internal
mixer. In addition, you can adjust the balance of the sound from the internal mixer and
from the computer.
NOTE
The reverb send, pan, volume and stereo link
settings are all saved when you end (
EXIT
)
audio interface mode and can be used again the
next time
You can be adjust the reverb send, pan,
volume and stereo link settings in the same
way as in recorder mode.
Operation is the same as in recorder mode.
(Reference: Operation Manual P.42)
PAN/EQ menu
VOLUME
Adjust the volumes of INPUTS 1–2.
0–127 (increments of 1)
Default value: 100
REV SEND
Adjust the reverb send levels of INPUTS 1–2.
0~100 (increments of 1)
Default value: 0
Reverb only affects the
monitored signal (as in
recording mode).
PAN (BALANCE)
Adjust the pan for INPUTS 1–2.
L100~R100
(increments of 2)
Default value: Center
(as in recording mode)
Link INPUT 1 and 2 to handle them as stereo
pairs.
On/Off
Default setting: Off
By setting up a stereo link, volume, reverb send and pan
track parameters can be shared by
INPUT 1 and 2.
(Reference: Operation Manual P.29)
Volume, reverb send, pan
Balance
In audio interface mode, the balance of the
input monitoring signal and the signal from
DAW software (the computer) can be adjusted
with the BALANCE knob.
Stereo link
Left
Only the INPUT
1–2 signals
Right
Only the DAW
stereo signal

Zoom R8 Specifications

General

Sample rate	96 kHz
Audio quality	24 bit
Microphone input impedance	1000 Ω
USB 2.0 ports quantity	1
Product color	Black

Weight and Dimensions

Weight	780 g
Dimensions (WxDxH)	257 x 190 x 51 mm