Zoom R8 - Cubase LE Installation Overview; Audio Interface; Control Surface

6
Audio interface manual
❶ ❷
Cubase LE installation overview
By using the between a computer and
external audio devices and instruments, their
signals can be recorded using a DAW or other
software. Instruments and mics that require
high impedance or phantom power can also
be connected.
Using the faders and keys on the
, you
can control transport operation and mixing in
digital audio workstation (DAW) software on
your computer.
To use the with DAW software, after installing that software, an audio driver must
be installed and set to recognize it.* We explain how to do this with Cubase LE.
Install DAW software
Install driver
ZOOM R8 audio driver*
Audio interface setup
Connect R8 to computer P.8
Device setup
Control surface setup
P.10, 30~
ZOOM R8 audio driver
Mackie Control
DAW software setup
Cubase LE
❶ Audio interface
❷ Control surface
Recording
P.16
Reference: "Cubase LE Startup Guide"
Reference: "Cubase LE Startup Guide"
Reference: "Cubase LE Startup Guide"
*No driver is necessary for use with Macintosh computers.