Edition 2 Chapter 1 Page 1-33
Feb/2013 Maintenance and Service
Before you put lubricant (grease) on a part by hand, clean the part then add
the lubricant.
Clean and lubricate all the sliding surface areas (bare metal, includes cylinder
pistons), not in the table, at a regular interval.
You cannot mix grease of different brands (specifications) or types.
When you inject lubricant (grease) with a grease pump, continue the
procedure until you see old grease come out of the joints.
1.18 ADJUST, CLEAN AND REPLACE THE PARTS
A. Adjustments
Table 1-7 Adjustments
Item Monthly Quarterly
Yearly
Adjust the adjusting bolt under the brake
pedal to make sure that the free stroke
varies from 0.4 to 0.86 in. (10 to 22 mm).
•
Adjust the limit screw on the steering
knuckle of front axles to ensure that the limit
screws on steering axles reach their limit
position at the same time.
•
Adjust engine fan, air compressor and
generator belts to between 0.4 to 0.6 in. (10
to 15 mm).
•
Figure 1-23 Adjustments
To Next Page
Loading...
Need help?
General
