Edition 2 Chapter 3 Page 3-23
Feb/2013 Inspection [document code]
Inspection
3.1 PRE-START INSPECTION
The following items should be checked each day before start-up and the start of
operations.
Examine the items below each day before you start or operate the crane.
ENGINE OIL
The level must be at the full mark.
COOLANT
The level must be near the top of the radiator tank.
LEAKAGE
Do a ground below the crane for signs of leaks.
FUEL
Engine fuel and propane / diesel for the top unit heater must
be sufficient for sustained operations.
LUBRICATION
Do the daily lubrication as necessary in the Lubrication
Recommendations.
HYDRAULIC SYSTEM
Examine hoses, tubes, components, reservoir sight gauge,
valves, pumps, motors, connections, reservoir oil
temperature, cylinder mount bushings and pins.
WIRE-ROPES AND HOOK
BLOCK
Examine the hoist wire-ropes, main hook, auxiliary hook and
the crane attachments for wear and damage.
TIRES
Examine the tires for correct pressure before you move the
crane. Only examine the tires when they are cold. Refer to
the Tire Pressure Chart on the Load Rating Chart.
WHEEL NUTS
When the crane is new (first 50 miles (80 km) of service) or
after a tire change, tighten the nuts daily. Tighten the nuts in
a pattern.
GENERAL CONDITIONS
Examine the crane for wear, leaks and damage.
TRANSMISSION OIL
Measure the level of transmission oil. The oil must be warm
(180 - 200° F (82.2 - 93.3° C)) and the engine at idle speed.
Make sure that the fluid level is at the HI mark.
FUEL FILTER
Daily: drain the water from the fuel water separator and fuel
filters.
SAFETY EQUIPMENT
Examine the safety equipment (lights, brakes and hazard
warning devices).
To Next Page
Loading...
Need help?
General
