Edition 2 Chapter 3 Page 3-25
Feb/2013 Inspection [document code]
Examine the level of axle oil (after initial
change)
Examine the battery condition
Examine the Engine Manufacturer’s Manual
for additional maintenance requirements
Inspect the tire pressure and condition
Examine the hydraulic cylinders and piston
rods
Examine the air system safety valve
Clean the crane weekly if it has salt on it to
prevent rust and corrosion
* Interval applies only to initial period of operation (break-in)
MONTHLY (100 – 200 HOURS)
Do the daily and weekly checks
Clean the radiator exterior
Do the monthly lubrication
Examine the Engine Manufacturer’s Manual
for more maintenance requirements
Examine the engine belts
Drain the hydraulic reservoir of moisture and
sediment
Replace the engine oil
QUARTERLY (500 HOURS)
Do the daily, weekly and monthly checks
Make sure that coolant system corrosion
inhibitor is full
Do the quarterly lubrication
Examine the Engine Manufacturer’s Manual
for more maintenance requirements
Drain the fuel tank of water and
sediment
Clean and wax all exterior painted surfaces
Replace the transmission filter
Replace the hydraulic return-line filters