©2019, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
4
Visit our website: https://zortrax.com/ to learn about the latest news and updates.
Printing process with the Zortrax Inkspire requires using synthetic resin which in a liquid form
is toxic and may cause allergic reactions. Therefore, you must protect your skin and eyes when
using the printer by wearing safety gloves and glasses. Provide proper ventilation in the print
room.
It is also extremely important to avoid spilling the resin on the printer and its surroundings
while operating the printer, filling the tank and removing prints from the platform. Ensure that
the printer is level and keep it on a stable surface. Do not remove the UV cover during the
printing process.
Do not leave the machine unattended during the printing process - check it periodically
for proper functioning in order to avoid potential accidents or breakdowns. Do not ignore
warnings and notifications displayed on the screen. Turn off the printer and empty the resin
tank once the printing process is finished.
Monitor your device for wear and tear regularly. Contact our Support Center via the support
form at: https://support.zortrax.com/support-form/ for assistance while replacing worn or
broken parts.
Keep the printer away from heat sources, flammable materials, equipment emitting radiation,
sources of fire, humidity, water and other liquids. To prevent any inadvertent use, keep the
device out of reach of children and animals. It is forbidden to drop or shake the printer as
it may cause breakdowns. The equipment is not intended for use in a potentially explosive
environment.
The Manufacturer strongly recommends setting up a special room dedicated only to 3D
printing. The room should be as free of daylight as possible and properly ventilated. It is
important to avoid situations in which liquid resin is exposed to daylight.
Workplace Health and Safety
All service and maintenance activities as well as device operation and maintenance require
using safety gloves and glasses included in the Starter Kit. It is also advisable to wear protective
clothing.
Keep the workplace clean. Containers with resin should be tightly closed and kept in a dark
place.
To Next Page
Loading...
Need help?
General
