©2019, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
45
16. Turn off the Ultrasonic Cleaner, remove the platform and leave it to air dry. Once the platform is dry,
install it back in the printer (A) and secure it with the screw (B).
Available Materials
The complete offer of materials is available at: https://zortrax.com/resins/.
Material Technical Data Sheets and Safety Data Sheets can be found at the same website.
When 3D printing with the Zortrax Inkspire, the Manufacturer recommends using Zortrax
certified materials to acquire the best possible quality of prints.
To Next Page
Loading...
