©2019, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
46
Basic Maintenance and Service Work
Maintenance work should be regular in order to keep the printer in good condition and
achieve high quality prints every time. Some parts require maintenance before each print
and some every few hundred working hours. All maintenance activities do not take much
time and are not complicated. Before commencing any repair, it is important to turn off
the printer and let it cool down. Remember to always wear gloves and glasses.
The printer is delivered with a full set of tools needed to carry out maintenance service
work.
The following tables present maintenance and repair guidelines connected with each
section of the Zortrax Inkspire, together with specific check points, necessary activities
and their frequency.
To Next Page
Loading...
