©2019, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
47
Activity Frequency Solutions to the problems Necessary accessories
Cleaning the machine,
its interior and sur-
roundings
Before each
printing
process
Remove dust and drops of resin
from the machine with paper
towels. If it’s necessary, use IPA.
-paper towels,
-IPA,
-safety gloves
Checking the degree of
wear of the carbon l-
ter and if it’s necessary,
cleaning it
Every 500
working
hours
- -
Replacing the lter Every 3-4
months
The lter is installed in the back
right corner of the printer’s
housing.
-a new lter
Cleaning the LCD
screen
Every
time the
resin tank is
removed
Soak a paper towel in IPA and
clean the LCD screen.
-paper towels,
-IPA,
-safety gloves
Cleaning the UV cover Once a week Clean the cover from dust using
a soft cloth.
NOTE! Do not use IPA or chemi-
cal detergents for that purpose.
-a soft cloth
1. Main
To Next Page
Loading...
