Chapter 19 Multicast
ES-2108 Series User’s Guide
145
19.7 General MVR Configuration
Use the MVR screen to create multicast VLANs and select the receiver port(s) and a source
port for each multicast VLAN. Click Advanced Application > Multicast > Multicast
Setting > MVR to display the screen as shown next.
" You can create up to three multicast VLANs and up to 256 multicast rules on
the Switch.
Your Switch automatically creates a static VLAN (with the same VID) when you create a
multicast VLAN in this screen.
Figure 79 Advanced Application > Multicast > Multicast Setting > MVR
The following table describes the related labels in this screen.
Table 46 Advanced Application > Multicast > Multicast Setting > MVR
LABEL DESCRIPTION
Active Select this check box to enable MVR to allow one single multicast VLAN to be
shared among different subscriber VLANs on the network.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
To Next Page
Loading...
