ZyXEL Communications ES-2108 - Status: Port Details; Figure 29 Status (ES-2108-G); Table 7 Status

Chapter 6 System Status and Port Statistics
ES-2108 Series User’s Guide
66
Figure 29 Status (ES-2108-G)
The following table describes the labels in this screen.
6.1.1 Status: Port Details
Click a number in the Port column in the Status screen to display individual port statistics.
Use this screen to check status and detailed performance data about an individual port on the
Switch.
Table 7 Status
LABEL DESCRIPTION
Port This identifies the Ethernet port. Click a port number to display the Port Details
screen (refer to Figure 30 on page 67).
Name This field displays the name of the port.
Link This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or another
value depending on the uplink module being used) and the duplex (F for full duplex
or H for half duplex).
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port (see Section 11.1.3 on page 103 for more information).
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP.
PD
(PWR model
Only)
This fields displays whether PoE (Power over Ethernet) is enabled (On) or disabled
(Off) on this port.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been
enabled on the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx KB/s This field shows the number of kilobytes per second transmitted on this port.
Rx KB/s This field shows the number of kilobytes per second received on this port.
Up Time This field shows the total amount of time in hours, minutes and seconds the port has
been up.
Clear Counter Select Port and type a port number or select Any to select all ports then click Clear
Counter to erase the recorded statistical information for a port or all ports.