Chapter 22 Loop Guard
ES-2108 Series User’s Guide
177
" After resolving the loop problem on your network you can re-activate the
disabled port via the web configurator (see Section 7.7 on page 80) or via
commands (see the CLI Reference Guide).
22.2 Loop Guard Setup
Click Advanced Application > Loop Guard in the navigation panel to display the screen as
shown.
" The loop guard feature can not be enabled on the ports that have Spanning
Tree Protocol (RSTP or MSTP) enabled.
Figure 102 Advanced Application > Loop Guard
The following table describes the labels in this screen.
Table 64 Advanced Application > Loop Guard
LABEL DESCRIPTION
Active Select this option to enable loop guard on the Switch.
The Switch generates syslog, internal log messages as well as SNMP traps when it
shuts down a port via the loop guard feature.
Port This field displays a port number.
To Next Page
Loading...
