ZyXEL Communications ES3500-24 - Page 80

Chapter 7 System Status and Port Statistics
ES3500 Series User’s Guide
80
The following table describes the labels in this screen.
Table 11 Status
LABEL DESCRIPTION
Port This identifies the Ethernet port. Click a port number to display the Port Details
screen (refer to Figure 29 on page 81).
Name This is the name you assigned to this port in the Basic Setting > Port Setup
screen.
Link For Ethernet ports, this field displays the speed (10M for 10Mbps or 100M for
100Mbps) and duplex (F for full duplex or H for half) settings.
For dual-personality interfaces with the RJ-45 port active, this field displays the
speed (10M for 10Mbps, 100M for 100Mbps or 1000M for 1000Mbps), duplex (F
for full duplex or H for half) and media type (Copper) settings.
For dual-personality interfaces with the SFP port active, this field displays the
speed (100M for 100Mbps or 1000M for 1000Mbps), duplex (F for full duplex or H
for half) and media type (Copper or Fiber) settings.
This field displays Down if the port is not connected to any device.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port (see Section 13.1 on page 124 for more information).
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been
enabled on the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx KB/s This field shows the number of kilobytes per second transmitted on this port.
Rx KB/s This field shows the number of kilobytes per second received on this port.
Up Time This field shows the total amount of time in hours, minutes and seconds the port
has been up.
Clear Counter Enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.