Chapter 18 Configuration: System
GS1900 Series User’s Guide
111
The following table describes the labels in this screen.
18.2.2 The IPv6 Sc re e n
Use this screen to view the IPv6 interface status and Switch’s management IPv6 addresses.
Click Co nfig ura tio n > Syste m > IP > IPv6 to open this screen.
Fig ure 110 Configuration > System > IP > IPv6
The following table describes the labels in this screen.
Table 57 Configuration > System > IP > IPv4
LABEL DESCRIPTIO N
IPv4 Address
Mode Select Static to define the IPv4 network properties or DHCP to allow the device to define the
properties.
IP Address Enter the IP address of the Switch in the IP domain.
Subnet Mask Enter the subnet mask of the Switch in the IP domain.
Gateway Enter the IP address of the default outgoing gateway in dotted decimal notation, for example
192.168.1.254.
DNS 1 Enter the IP address for the primary domain name server. DNS (Domain Name System) is for
mapping a domain name to its corresponding IP address and vice versa.
DNS 2 Enter the IP address for the secondary domain name server. DNS (Domain Name System) is for
mapping a domain name to its corresponding IP address and vice versa.
Management
VLAN
Enter the port number of the management VLAN.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 58 Configuration > System > IP > IPv6
LABEL DESCRIPTIO N
IPv6 Address
DHCPv6 Client Select Ena ble to allow the device to act as a DHCPv6 client or Disa ble to disallow it. This field
displays the Switch’s DHCP settings when it is acting as a DHCPv6 client.
Auto
Configuration
Select Ena ble to allow the device to auto-configure the IPv6 properties or Disa b le to manually
enter the properties.
IPv6 Address Enter the IPv6 address of the Switch in the IP domain.
Gateway Enter the IPv6 address of the default outgoing gateway.
To Next Page
Loading...
