ZyXEL Communications GS1900-10HP - The VLAN Screen

Chapter 26 Configuration: Multicast
GS1900 Series User’s Guide
162
26.2.2 The VLAN Sc re e n
Use this screen to view the IG MP VLAN settings. Click Config ura tio n > Multic a st > IGMP > VLA N to open
this screen.
Fig ure 161 Configuration > Multicast > IGMP > VLAN
The following table describes the labels in this screen.
Unknown
Multicast Action
Select to send the IPv4 unknown multicast frame to the router port. The following options are
available:
• Floo d – select to send the frames to all ports.
• Dro p – select to discard the frames.
• Ro ute r Po rt – select to send the frame to router port.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 107 Configuration > Multicast > IGMP > Global (continued)
LABEL DESCRIPTIO N
Table 108 Configuration > Multicast > IGMP > VLAN
LABEL DESCRIPTIO N
IGMP Vlan
VLAN ID Displays the ID of a static VLAN; the valid range is between 1 and 4094.
State Display the status of the VLAN as enabled or disabled.
Router Ports Auto
Learn
Displays the Switch learn multicast router port member status of any VLANs as enabled or
disabled.
Query
Retry Displays the number of query retry times.
Interval Displays the amount of time (in seconds) between general query messages sent by the router
connected to the upstream port.
Max. Response
Interval (sec)
Displays the amount of time (in seconds) the router connected to the upstream port waits for a
response to an IGMP general query message.
Last Member Query
Count Displays the number of queries.
Interval Displays the amount of time (in milliseconds) between the IGMP group-specific queries sent by
an upstream port when an IGMP Done message is received.
Querier
State Displays the Switch current VLAN querier entry as Ena ble or Disa b le .
Version Displays the Switch current VLAN querier entry version.
Edit Click Edit to change the properties of the IGMP VLAN entry.