ZyXEL Communications GS1900-10HP - The Trap Destination Add Screen

Chapter 32 Configuration: Management
GS1900 Series User’s Guide
223
32.3.10 The Tra p De stina tio n Add Sc re e n
Use this screen to configure the Tra p De stina tion settings. Click Co nfig ura tion > Ma na g e m e nt > SNMP >
Tra p De stina tion > Add to open this screen.
Fig ure 228 Configuration > Management > SNMP > Trap Destination > Add
The following table describes the labels in this screen.
Version Indicates the SNMP trap supported version. Possible versions are:
• v1: Set SNMP trap supported version 1.
• v2c : Set SNMP trap supported version 2c.
• v3: Set SNMP trap supported version 3.
Community/User
Name
Displays the community or user name that this entry belongs to.
UDP Port Displays the trap use destination for the UDP port.
Action
Delete Click De le te to remove the entry.
Add Click Add to create a new SNMP Tra p Ho st entry.
Table 175 Configuration > Management > SNMP > Trap Destination (continued)
LABEL DESCRIPTIO N
Table 176 Configuration > Management > SNMP > Trap Destination > Add
LABEL DESCRIPTIO N
Trap Destination
Server Enter the IP address of the server or a string identifying the server address that this entry belongs
to.
Version Select the SNMP trap supported version. Possible versions are:
• v1: Set SNMP trap supported version 1.
• v2c : Set SNMP trap supported version 2c.
• v3: Set SNMP trap supported version 3.
Community
Name
Displays the community name that this entry belongs to.
User Name Displays the user name that this entry belongs to.
UDP Port Enter a UDP port for this entry.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.