Chapter 18 Configuration: System
GS1900 Series User’s Guide
112
18.3 Tim e
The Time option is used to setup the system time and SNTP (Simple Network Time Protocol) server settings.
18.3.1 The Syste m Time Sc re e n
In the navigation panel, click C o nfig ura tio n > Syste m > Tim e > Syste m Tim e to display the screen as
shown.
Fig ure 111 Configuration > System > Time > System Time
The following table describes the labels in this screen.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 58 Configuration > System > IP > IPv6 (continued)
LABEL DESCRIPTIO N
Table 59 Configuration > System > Time > System Time
LABEL DESCRIPTIO N
System Time
Enable SNTP Select Ena b le to enable using a simple network time protocol (SNTP) server to manage the
system time or Disa b le to manually manage system time.
Manual Time Select the system date and time values from the dropdown lists.
Time Zone Select the time zone from the dropdown list.
Daylight Saving
Time
Select Ena ble to use Daylight Saving Time to offset the system time or Disa ble to not adjust
system time.
Daylight Saving
Time Offset
Enter the daylight saving time offset value in minutes.
Start Date Select the start date of the daylight saving time period from the dropdown lists.
End Date Select the end date of the daylight saving time period from the dropdown lists.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
